哈尔滨爱彼表维修店-欢迎资讯

爱彼(AUDEMARS PIGUET)售后服务中心客服电话：400-875-1181(请您提前预约避免工作人员因国家法定假日调整上下班时间和维修人员过多而给您带来不便!)

　　【瑞亨爱彼：手表售后维修中心门店图】

　　【图为爱彼：手表抛光工作台】

　　【上图为爱彼：手表做真空、压缩、冷凝及防水测试的设备】

　　人们在夏季常常因较多运动而大汗淋漓，由于汗水中的酸碱值不同，腕表的材质也不同，汗水和撞击对表侵蚀的程度也不尽相同。所以夏季对腕表的保养显得更为重要。不同材质的腕表，保养方面也有着不一样的重点。

　　珠宝表

　　珠宝腕表不仅是计时工具，更是亮丽的首饰，因此它更需要细心的呵护，才可常保闪耀如新。

　　在夏季的时候由于衣着少、易碰撞，很容易造成宝石的松动甚至脱落。

　　保养重点：

　　1.珠宝腕表最怕撞击，夏季运动时应尽量将表取下。

　　2.宝石要避免被腐蚀和硬物摩擦，喷香水或者做粗活的时候应将表取下，以免宝石被腐蚀或磨损。

　　3.每次佩戴前需要检查宝石是否有松动，如有需要立即送往表店修理。

　　机械表

　　机械腕表机芯在潮湿空气中或受腐蚀性气体的侵蚀会出现锈蚀现象， 若长期被汗水侵蚀或听任酸碱盐污物积聚而不擦去，腕表就会慢慢出现锈斑，尤其是后盖低凹处容易出现。 特别是在多雨的夏天最易造成配件的生锈而损坏。

　　保养重点：

　　1、硅胶干燥器。根据修理单位的规模和需要，应备有一个或几个干燥器，以存机械腕表机芯，避免机芯零件受潮后生锈。

　　2、快速去锈液。775毫升上述溶液，将机械腕表机芯部件放入其中很快即可除锈。具体浸泡时间视零件生锈程度而定。

　　高硬度材质

　　碳化钨硬质合金、高科技陶瓷、蓝宝石玻璃等材质的特点是硬度高、耐磨性强，此材质的腕表经长期佩戴后外观仍可保持光洁如新。但夏季常常户外运动，如不慎碰撞，会发生划伤外观表面的现象。

　　保养重点：

　　1.夏季在打球等运动前，应该取下手表。这些高硬度材质的抗弯强度和冲击韧性不如不锈钢。因此应尽量避免敲击、撞击或坠落在坚硬地面上。

　　2.平时可用牙刷蘸少许沙拉轻刷手表，将污渍去除。

　　镀层/K金材质

　　镀层和K金化学稳定性好、耐磨，但是白色的K金、玫瑰金经过长时间的佩戴，尤其是在多汗的夏季很可能出现轻微的变色，这是因为人体汗液中有少量的氯化物、乳酸、尿素氨等，这些物质与K金接触后可能会发生化学反应，产生微量深黑色的化学盐。

　　保养重点：

　　1.K金材质主要是需要避免夏季汗水的腐蚀，应该最好定期用湿棉布轻轻擦拭，以去除汗渍和灰尘。

　　2.擦洗或者清洗后可用吹风机将表吹干。

　　people in the summer often due to movement of sweat, sweat due to the pH value in different materials, the watch is different, and the impact on the sweat erosion degree is not the same. So the maintenance of the watch is more important in summer. Different materials of the watch, maintenance also has a different emphasis.

　　jewelry table

　　jewellery is not only the timing tool is more beautiful jewelry, so it need careful care, can keep shining like new.

　　in the summer due to less clothing, easy to crash, it is easy to loose the gem and even fall off.

　　maintenance focus:

　　1 Joaillerie most afraid of impact, try to take the summer sports table should be.

　　2 gems to avoid corrosion and hard friction, perfume or to do menial work time should be taken to avoid the stone table, corrosion or wear.

　　3 each wear before the need to check whether the gem is loose, such as there is a need to immediately rushed to the shop repair shop.

　　mechanical table

　　The erosion of

　　mechanical watch movement in the moist air or corrosive gases will be corroded, if the long-term erosion by sweat or allow alkali salt buildup dirt and does not wipe, the watch will slowly appear rust, especially prone to cover the concave. Especially in the rainy summer, the most likely to cause parts of the rust and damage.

　　maintenance focus:

　　1, silica gel dryer. According to the size and repair units need, should be equipped with one or several dryer, to keep the mechanical watch movement, avoid the machine parts with rust.

　　2, quick to rust liquid. 775 milliliters of the solution, the mechanical watch movement parts into which can be quickly rust. The specific immersion time depending on the degree of rust parts.

　　high hardness material

　　The characteristics of

　　tungsten carbide hard alloy, high-tech ceramics, sapphire glass material is of high hardness, wear resistance, the material of the watch after long-term wear appearance can keep clean. But in the summer, often outdoor sports, such as careless collision, will happen to scratch the appearance of the appearance of the phenomenon.

　　maintenance focus:

　　1 in the summer before playing and other sports, should take down the watch. The bending strength and impact toughness of these high hardness materials are not as high as those of stainless steel. So try to avoid hitting, hitting, or falling on the hard ground.

　　2 usually can be used in a small brush dipped in a toothbrush brush watch, remove stains.

　　gold coating material

　　gold plating and good chemical stability, abrasion resistance, but the white gold, rose gold after a long time to wear, especially a slight discoloration is likely in the sweaty summer, this is because there is a small amount of chloride, lactic acid, urea and ammonia in human sweat, these substances with K gold contact may occur after chemical to produce a chemical reaction, deep black trace salt.

　　maintenance focus:

　　1 carat gold is the main material to avoid corrosion of summer sweat, should be the best regular with a wet cloth to gently wipe the sweat and dust removal.

　　2 scrubbing or use hair after washing machine to dry table.

分享到：