沈阳劳力士官方指定手表售后维修-中国区服务中心

劳力士(Rolex)售后服务中心客服电话：400-875-1181(请您提前预约避免工作人员因国家法定假日调整上下班时间和维修人员过多而给您带来不便!)

　　【劳力士：手表售后维修中心门店图】

　　【图为劳力士：手表抛光工作台】

　　【上图为劳力士：手表做真空、压缩、冷凝及防水测试的设备】

　　劳力士手表机械表现在已经不单单只是用来计时了，还是一种品位的象征。如果长期没有佩戴机械表可能会导致机械表不走了。久未佩戴的表款如果要重新调整时间，则必须要特别注意操作方式，以免造成齿轮卡榫故障，内部零件无法正常运转，如果进行了机械表保养，表款需要花的维修费用可以降至最低。

　　劳力士手表机械表保养走时精度：

　　长时间的静置，机械表的发条自然放松至表款静止不动，此时，若要重新佩带，就必须先重新上紧发条，之后再校准时间，一般机械表在发条最松的时候，会出现时针、分针变慢或变快的现象，所以，应该先上紧发条，以免校准时间后，没有标准动力驱动指针，即使是自动上炼表款，也应先用手动上炼至八分满，再进行时间校准。

　　劳力士手表自行机械表保养的原则：

　　凡是从事过水上活动的表款，都需要做保养，尤其经过海水盐分的浸泡，游泳池内过滤水质的化学物品，都容易造成表款防水垫圈的侵蚀、硬化;有些保养是可以自己在家做的，容易的以软布用少量肥皂水清洗金属及防水橡胶表带，最后并以湿布清除肥皂水擦拭过的痕迹后阴干，就可以达成初步保养的性能，同时，千万不要将表直接送到有超音波设备的地方做清洗，因为超音波的清洗有分强、弱不同频率，一但使用不对的超音波频率，就容易造成内部零件松脱。

　　{brand name} watches mechanical performance is not only used to time, or a symbol of taste. If there is no long wear mechanical watch may lead to mechanical table does not go. For a long time without wearing the watch if you need to adjust the time, we must pay special attention to the mode of operation, so as to avoid the gear fault tenon, the internal parts can not operate normally, if the mechanical watches need maintenance, the maintenance costs can be reduced to the minimum.

　　watch mechanical watch maintenance travel time accuracy:

　　The static

　　long time, mechanical watch spring relaxed to watch motionless, at this time, if you want to wear, it must be rewound, then calibration time, general mechanical table when spring loose, there will be an hour hand and a minute hand slow or fast, so should a wound, so as to avoid the calibration time, there is no standard driving pointer, even the automatic mixing table, it should use manual mixing to eight minutes, then the time calibration.

　　{brand name} watches the principle of mechanical maintenance of the table:

　　all engaged in water sports watches, all you need to do maintenance, especially after seawater salt immersion, chemicals in the pool of water filtration, are likely to cause erosion, surface hardening waterproof gasket; some maintenance can make at home, easy with a soft cloth with a small amount of soap and water cleaning waterproof rubber and metal watchband, and finally to remove wet soapy water wipe traces after dried, performance can reach preliminary maintenance at the same time, do not be sent directly to a table of ultrasound equipment, local cleaning, ultrasonic cleaning because of strong and weak points with different frequencies, but not the use of a supersonic frequency and it is easy to cause the internal parts loose.

分享到：